Re: Split Mould Casting Technique
Posted: Tue Jun 30, 2015 7:54 pm
I see, thanks. I have another question. How do you put amount of resin into mould and rest into reservoir? Do you open mould a bit? This would be a bit messy.
Then turn on vacuum to get rid of big bubbles (I expect some border, to catch up resin expansion) and next turn presure to minimalize small bubbles.
I use for only pressure casting syringe with needle. But for typical resin with working time 3 minutes max it is not effective and labourious.
I hope combined casting will solve that.
Then turn on vacuum to get rid of big bubbles (I expect some border, to catch up resin expansion) and next turn presure to minimalize small bubbles.
I use for only pressure casting syringe with needle. But for typical resin with working time 3 minutes max it is not effective and labourious.
I hope combined casting will solve that.